▲ Restart the printer.
1. Run Service “Curing system monitor”.
2. Reseat/replace Curing Control PCA Temperature Sensors Cable.
3. Reseat/replace Temp. Sensors.
If this doesn’t solve the problem call or email one of our service engineers:
peter.martins@bristolinkjet.co.uk
07866 607 321
david.elliott@bristolinkjet.co.uk
07384 618 743
SE Code: 16.90:10 – Air Curtain: Temperature sensor failure or not connected.Problem description: Air Curtain and Printzone Heaters Control/Curing Control PCA...
SE Code: 16.85:03 – Air Curtain burst resistor: Out of range.Problem description: Air Curtain Resistors.Corrective action: ▲ Restart the printer. ▲...
SE Code: 16.84:03 – Air Curtain steady resistor: Out of range.Problem description: Air Curtain Resistors.Corrective action: ▲ Restart the printer. ▲...
SE Code: 16.83:11 – Vapour burst resistor: Not connected.Problem description: Air Curtain and Printzone Heaters Control to Curing Power Interconnect PCA...
SE Code: 16.82:11 – Air Curtain steady resistor: Not connected.Problem description: Air Curtain and Printzone Heaters Control to Curing Power Interconnect PCA...
SE Code: 16.61:10 – Vapour removal system: vapour fans array 1 fault.Problem description: Air Curtain and Printzone Heaters Control/Curing Control PCA...
SE Code: 16.51:01 – Curing system: pressure not reachable. Printer is limiting working pressure.Problem description: Silent SE. Customer symptoms are: slower...
SE Code: 16.50:10 – Severe SE: Pressure calibration failure together with NVM values = 0 (failure at first startup).Problem description: Pressure calibration...
SE Code: 16.50:03 – Curing system: pressure calibration error.Problem description: Silent SE: If there's already a valid pressure calibration in NVM, and new...
SE Code: 16.44:10 – Curing system: module 4 failure.Problem description: ENWW Continuable and non-continuable error codes 99.Corrective action: ▲ Restart the...